dvq.ca

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/floating_dock.html

Pickering, Ontario, Canada. 10 Inch Hoop Pile Holder. 12 Inch Hoop Pile Holder. These connectors are for use on pile driven docks or where lake conditions are extremely rough. Use one set of floating connectors (4 in set) and one set of center connectors (2 in set) for docks up to 10 feet wide. For docks over 10 feet wide add additio. Corner Connector (no cap). Corner Connector with end cap. For use on any inside corner on a Floating Dock or Ramp. These connectors are for use on pile driven docks or wher...

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/wood_leg.html

Pickering, Ontario, Canada. Wood Leg Dock Components. 2x4 Wood Side Bracket. For use on a 2x4 leg in the same manner as the 4x4 Wood Side Bracket. Used on a 4x4 Wooden Leg in the same manner as our Pipe Brace Bracket. The 4x4 Drive Cap, in conjunction with the 4x4 Point, will enable you to seat the wooden leg into the Lake bottom with a hammer without damaging the 4x4 leg. 4x4 Wood Base (11 Inch Diameter). 4x4 Wood Corner Bracket. 4x4 Wood Side Bracket. Our Second Best Sellers" The 4x4 Wood Side and Corn...

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/pipe_leg.html

Pickering, Ontario, Canada. Pipe Leg Dock Components. 1 1/2 Inch Brace Bracket. The Brace Bracket should be used on installations where there is deep water, or if a boat is often moored at the dock, to eliminate side motion. 1 1/2 Inch Clamp on Brace Bracket. Used in the same manner as our Brace Bracket but clamps over the outside of the pipe for easier installation. 1 1/2 Inch Pipe Base. 1 1/2 Inch Pipe Corner Bracket. 1 1/2 Inch Pipe Point. The Pipe Point can be used in any situation, but is very helpf...

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/index.html

Pickering, Ontario, Canada. Established in 1986, we offer our customers the most complete, safe and effective line of cast aluminum dock, deck and bridge hardware on the market. Since we have our own manufacturing plant, we can even custom cast parts to your specifications. Also, you can be assured that you will receive the highest quality product with on time delivery, all at very competitive prices. Designed by Daniel Quattrociocchi.

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/dock_hardware.html

Pickering, Ontario, Canada. Dock Hardware and Components. 10 Inch Zinc Alloy Cleats. Cast from a very durable Zinc Alloy, these cleats are used where more strength is required. 12 Inch Zinc Alloy Cleats. Cast from a very durable Zinc Alloy, these cleats are used where more strength is required. 2 1/2 Inch Dock Edge Bumper. Nails or screws onto edge of dock to prevent damage to your boat. (Second bumper shown). 3 1/2 Inch Dock Edge Bumper. 4 1/2 Inch Dock Edge Bumper. 4x4 Leg Safety Hook. 8 Inch Open Cleat.

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/ladders.html

Pickering, Ontario, Canada. 2x4 Angle Ladder Mounting Bracket. This bracket will tilt your ladder outward at a 12 degree angle for a comfortable climb up. Use in the same manner as our 2x4 Ladder Mounting Bracket. 2x4 Ladder Mounting Bracket. Insert 2x4 Ladder into both brackets, and drill through. Insert 3/8 inch bolt, washer and nut. The mounting Brackets bolt to the end or side of the dock or deck with four 3/8 inch bolts. Tighten until teeth are seated. 3 Step 2x4 Ladder. The Stationary Straight Ladd...

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/building_dock.html

Pickering, Ontario, Canada. In the July 2000 issue of Field and Stream Magazine. An article was published on building "A Dock of Your Own" (written by John Decker). The article is about building a dock using RDS hardware, and even gives a material list. To view this article, you will need Adobe Reader installed on your computer to view the PDF file. If you already have Adobe Reader installed, please click the appropriate link below. A Dock of Your Own. Field and Stream, July 2000 (written by John Decker).

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/deck_hardware.html

Pickering, Ontario, Canada. Can be used for any width 2"x, for floor or ceiling joists. Pressure treated lumber tends to warp and twist as it dries. The 2x2, 2x4 and 2x6 brackets securely hold rail ends in position to minimize distortion. Nails and screws do not. Ideal for building stairs or railings. Pressure treated lumber tends to warp and twist as it dries. The 2x2, 2x4 and 2x6 brackets securely hold rail ends in position to minimize distortion. Nails and screws do not. Double Deck Stand Off.

rdscanada.ca

RDS Canada - Dock Hardware

http://www.rdscanada.ca/prefab.html

Pickering, Ontario, Canada. Pipe Leg Dock Components. Dock, Aluminum, 4' x 10', Frame Only. Dock, Floating, 4' x 10', Cedar Decking. Dock, Stationary, 4' x 10', Cedar Decking. Designed by Daniel Quattrociocchi.