flowkooler.com
why is it overheating | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/cooling_faq.html
1 Doesn't coolant need more time in the radiator to cool? But a lot of people still think so. We have come up with some explanations for the Doubting Thomas. Debunking the I Can Have It Both Ways Theory. Debunking The Conscientious Electron Theory. Debunking Grandpa's Flathead Theory. Simply put, you have a far better chance of keeping your cool with greater flow rate through your heat exchanger and exiting the system than holding it in your heat exchanger while generating heat in your engine block.
flowkooler.com
Installing a Water Pump | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/info/pump_installation_instructions.html
Before installing your new Flowkooler water pump:. 1) DO NOT PAINT YOUR PUMP BEFORE CHECKING IT IS CORRECT FOR YOUR APPLICATION. We cannot accept returns due to fit if they are unsaleable as new pumps. Thoroughly flush and drain the cooling system. 4) Check hoses, clamps, radiator. Examine the hoses, clamps, and the radiator and cap. Repair or replace if necessary. 5) Gain working room. Remove all belts that ride on the fan pulley. 7) Remove the fan. 8) Inspect fan clutch. Check clearance with open back ...
flowkooler.com
Direction of water pump | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/info/standard_reverse_rotation.html
UNDERSTANDING STANDARD & REVERSE ROTATION PUMPS (CLOCKWISE, COUNTERCLOCKWISE & BI-DIRECTIONAL). Refer to the belt path diagram under the hood, typically located on the fan shroud or front fender brace, or locate the water pump pulleys on the vehicle. Compare the diagrams below. Water pump pulleys running on the inside. Surface of the belt indicate a Standard Rotation. Water pump (grooved side of belt). Water pump pulleys running on the outside. Surface of the belt indicate a Reverse Rotation.
flowkooler.com
SPAL Fan Parts & Tech Sheets | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/spal-fan-distribution.html
SPAL Fan Parts & Tech Sheets. We stock quite a few fans but if a SPAL fan is not a stocked item, we are happy to special order it for you and have it drop ship directly from SPAL. Tech Sheets and part numbers are provided for your convenience. 185 Degree Thermostat, Relay and Wiring Harness. 185 Degree Thermostat (stainless steel 3/8 pipe thread). 195 Degree Thermostat, Relay and Wiring Harness. 195 Degree Thermostat (stainless steel 3/8 pipe thread). Pull 5.6 Paddle Blade Motorcycle/ATV Fan. Pull 13 Str...
flowkooler.com
Custom Copper Heater Cores to Replace Aluminum & Plastic | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/custom-copper-heater-cores-to-replace-aluminum-plastic.html
Custom Copper Heater Cores to Replace Aluminum & Plastic. We make our own cores and fabricate our own tanks we can work in batch sizes of one or fifty or five hundred. We use copper and brass so our heater cores are less prone to electrolytic actions or stress failure than the aluminum alternative. We use copper for our heater cores because copper has twice the BTU transfer rate of aluminum making it an even makes a better heat exchanger. We make it here in the United States and we make it to last.
flowkooler.com
Fan Clutch | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/info/fan_clutch_overview.html
Did my Fan Clutch Fail? Fan noise is sometimes evident under the following normal conditions:. When clutch is engaged for maximum cooling. During first few minutes after start-up until the clutch can redistribute the silicone fluid back to its normal disengaged operating condition after overnight settling. 3) Silicone Fluid Leak. The operation of the unit is generally not affected by small fluid leaks which may occur in the area around the bearing assembly. If the degree of leakage appears excessive,...
flowkooler.com
FlowKooler, leading distributor of SPAL Fans and Accessories | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/spal-fans.html
SPAL designs, produces and markets an extensive range of high performance electric axial cooling fans and FlowKooler distributes them all over the world because we use the SPAL fans and have not found a better 12 volt fan on the market than SPAL. Fans are available for sales in the FlowKooler store. What SPAL fan do I need to cool my vehicle? The efficiency of your cooling system depends on many factors:. Radiator design and materials used e.g. Copper. What about the 6 Volt? SPAL does not make a six volt...
flowkooler.com
How your cooling system works | FlowKooler Hi Flow Water Pumps
http://www.flowkooler.com/info/cooling_system_overview.html
The radiator is responsible for transferring heat from the circulating coolant to the air passing through it. Heated coolant flows into the top of the radiator from the engine. The coolant is passed through a series of tubes and fins that effectively dissipate the heat in the coolant. 4) Coolant Recovery Tank. The coolant recovery tank serves as a reservoir. It receives coolant expelled from the cooling system through the pressure valve in the radiator cap. It holds the expelled coolant for reint...The f...
thebrassworks.net
Crazy things we get up to | The Brassworks
http://www.thebrassworks.net/crazy-things.html
Call Now: 805.239.2501. Classics & Street Rods. Gas Tanks and Brass Lights. Model T Speedster Radiators. 1906-1908 Model N,R and S. 1928-1931 Model A and AA. 1932 Model B and Flathead. Restored and Fabricated Radiators. 1909-16 Model T Parts. 1917-27 Model T Parts. Crazy things we get up to. Sometimes our customers struggle to articulate the “chop” they want. Most chopped radiators we see are 1932 chopped radiators and Model A chopped radiators but there are others. This chop was so significant we made u...
flowkooler.com
Water Pumps - Flowkooler Water Pumps - Robertshaw Thermostats - SPAL Fans & More
http://www.flowkooler.com/store/index.php
Use keywords to find the product you are looking for. Radiator Caps and Parts. Would you like to login. Or create an account. New Products For April.